Body Vision PT600 Power Tower


Updated at 12/16/2015 15:43:34 - Details
Comments(10)

Zhijun Good price and good service.

Mark Every piece of this station is rigid, the finish is excellent, the hardware is quality, and everything fits together (in under an hour) nicely. The instructions are simple, straight forward and if you can finish a "connect the dots" you'll do just fine putting this together. All you'll need for assembly is a couple of adjustable wrenches, and a phillips screwdriver. Most every piece will fall into place with a solid wrap with the edge of your palm with no pain, no swearing. A 13mm and 17mm wrench, a ratchet with corresponding sizes and a #3 phillips will shave quite a bit of time off of assembly. It's worth noting that the base of the station already has caps installed, all handles are assembled, so no fighting them onto the metal.



Once this station is together, it's very rigid, very sturdy. Perhaps all I can complain about is that the foam on the pull-up bar isn't attached very well, and rolls around a bit -consider it an advanced forearm workout. Keep an eye out for height on this one. Low ceilings will have you inspecting your attic space the hard way. Check product height with ceiling height before deciding to purchase it.



As I said before, it's a sturdy station with quality construction, though when my larger frame is torquing on it during a workout, there is a small amount of flexing in the dip handles and main support tubes. This is negligible and to be expected in my opinion. I never feel like it's not going to support my weight. There's plenty of room between the dip bars to do pullups, as long as you fold the knee-raise grips down. I did find it's easy to thump your noggin on the pullup bar doing dips, but I found that by turning around and facing out nullified this problem, and didn't impact my workout at all so again... negligible issue. The back padding has a nice lumbar curve, which may or may-not fit your back as we're all different shapes and sizes, but I find it to be a good design none the less, and shouldn't cause anyone any problems during knee-raises. Finally, the push-up handles are a good width apart, very sturdy and luckily -they're thicker than the other grips allowing a much more comfortable excercise without bruising your palms. It also allows you to do deep, full-range pushups that are superior to floor-based push-ups.



All-in-all, this station is nice to look at, well-built, a great space saving design over similar models (as the pullup bar is on the front side) easy to assemble, easy to move around, and a rippin' deal for the money. If a person were to merely couple this station with a jump rope, and some dumbells you could accomplish an effective full-body workout routine capable of great results in looks and strength, all in a small amount of floor space like the corner of a bedroom. It's everything I expected out of it and a little more -especially for the money.

thealienmedic I had been wanting this item as an addition to my home workout room. With $ being tight, especially around the holidays, I had resigned myself to the fact that I would be waiting for a while longer. When I found this item with the [...], I knew I had found the viable option that I had been searching for. [...], assembly was easy (but still not my favorite), and the item appears to be more heavy duty than other models in the same price range. Very excited and satisfied thus far... Thanks!!!

Dwayne I had been wanting this item as an addition to my home workout room. With $ being tight, especially around the holidays, I had resigned myself to the fact that I would be waiting for a while longer. When I found this item with the [...], I knew I had found the viable option that I had been searching for. [...], assembly was easy (but still not my favorite), and the item appears to be more heavy duty than other models in the same price range. Very excited and satisfied thus far... Thanks!!!

Leigh This product came in a long flat box. It took about 1.5 hours to put together and was easy to assemble. I, of course, was taking my time to make sure I followed the directions. I tried the product and it was very sturdy. I'm 5'-8" and 160 lbs. Thank you Hayneedle edge for making my shopping experience wonderful.

Daniel Easy to assemble with wrench and socket set. Pleased with the quality of the paint. Hand grips for chin ups/standard pull-ups could be of better quality/durability. With the space saving design, I would not encourage anyone to do kips on this equipment for fear of it tipping over. Normal dips/pull-ups, etc. are fine. I am pleased overall with the purchase.

Jeremy I received the Body Vision Power Tower on Saturday and immediately assembled it. Assembly was relatively straightforward with only a couple of wrenches and a phillips screwdriver required. Tower is good quality with solid construction and extra bracing in strategic areas. It sits level and is very stable during use.

Retired Military Very easy assembly and very sturdy tower. Only problem is that the angled design puts the structure too close when doing pullups. Have to be very careful not to hit the back and sides.

Project339 You can feel a good workout from this product! i love it.



Make sure you have at least two adjustable wrenches and it'll be it very easy to assemble.

John Sturdy, easy to assemble, pleasently suprised. Arrived 2 days earlier than promised also. Great value.



X

Share this product and let your friends discover some cool new stuff!

Body Vision PT600 Power Tower

Scroll to Top